Wrapping a bus
- Started
- Last post
- 30 Responses
- OSFA0
dude, c'mon, everyone knows how to do this in japan since 1976 ;) hehe
- dirtydesign0
pick a vendor
get a dieline
designi just a fleet of unimogs. turned out pretty rad.
- Knuckleberry0
straight on shot, get a measurement for scale. do it in illy with cadtools plug-in. done.
Do not try and apply it yourself. Get another place to do it. So if they make a mistake it is on them, not you. Trust me... bad times.
- hektor9110
I did one for a construction company.... it was a rush job. when to job site... measure everything added about .15 inches on each side and came out to be pretty good.
- marychain0
I do these a lot.
You need to contact the bus company....who built the bus and ask for the side elevations....they will have the dimensions.
I usually end up then creating a template in Illustrator based on the elevations drawing.
Contact me if you want to discuss...I just finished one and I'm doing another now.
- i_monk0
Client: "I am not able to get specifications for the bus."
I'm emailing the bus manufacturer, but if they don't come through I'm going to have to measure this bitch myself.
- ceiling_cat0
i jizz all over this bus
- iheartfun0
Whoever you out source it to should have a dieline! Its that simple unless you were planning on printing and cutting it out youself.
- Pixter0
Yo dawg, I've heard you like buses so I put a bus in your bus so you can buzz while you buzz