3ds Max question...

  • Started
  • Last post
  • 1 Response
  • yovkov0

    Seems like your working on mesh, and shiuld convert it to poly?

  • kalkal

    I know most of you lot who use 3D modelling (seemingly) tend to use cinema 4D but, just by the off chance that someone here does use 3Ds Max, I'm doing a edge model bust, I'm separating the edge loops out into 'areas' to make animating clearer but on selecting some polys (which as far as I figure should all be quads) the selection tool is only selecting a try instead of the full poly. Tried welding the corners just in case there were any strays there, but everything seems fine. Any ideas what could be causing this?